How to Solve a Maze on Paper: 3 Methods That Work

How to solve a maze on paper: follow one wall (the right-hand rule), fill in dead ends, or work back from FINISH. Three methods, step by step.

By Pepe Rivera · About 4 minute read

To solve a maze on paper, put your pencil on START, keep one hand on the wall beside you, and follow that wall without lifting your hand. This is the right-hand rule (the left hand works the same way). On a maze with no loops, like every maze on this site, it always reaches FINISH. To see the route without any detours, shade the dead ends first.

STARTFINISH
Easy maze 1 with its solution. Following the right-hand wall from START ends on this same route, after detours into dead ends. See all easy mazes.

Know what kind of maze you have

Every maze on this site is a connected network with exactly one route between any two cells. There are no loops and no sealed-off islands of wall. START is at the top and FINISH is at the bottom. Easy mazes are 10 cells across and 13 down, medium mazes are 15 by 19, and hard mazes are 20 by 26. Each level has twenty-four mazes.

This structure matters because it limits the ways to go wrong. Since there is only one route, the only traps are dead ends, and each dead end can be escaped by going back to the last junction. All three methods below rely on that fact.

Method one: follow the wall (the right-hand rule)

Place your pencil or fingertip at START and choose a hand, say the right. Keep that wall alongside you as you move. Turn right whenever you can, go straight if you cannot, turn left if you must, and turn around at a dead end. Because every wall in our mazes is connected to the outside edge, this rule always reaches FINISH.

The wall follower never needs memory or planning, which makes it comforting. Its drawback is length: you walk into every dead end along the way. Use it with a fingertip first, then draw the route once you know it. A short maze like the easy ones is a good place to practice, because the detours are short and the pattern becomes clear after a few attempts.

Method two: fill in dead ends

Scan the maze for corridors that are closed on three sides. With a very light pencil, shade each one from its closed end back to the first junction. Once a corridor is shaded, a junction may turn into a new dead end, so look again. Repeat until nothing is left to shade.

Because there is only one route, shading every dead end leaves exactly that route standing. This method rewards patience, and it is a good choice for a large hard maze, where a wall follower would take a long time. Use a soft eraser and a gentle touch so the shading does not hide the walls.

Method three: work backward from FINISH

Start at the bottom and trace toward START. The route is the same in both directions, but the number of dead ends you face can differ greatly. A maze that traps you near START may be gentle near FINISH, and the reverse is just as likely.

If you get stuck, switch ends. Many solvers like to alternate, working a short way from each end and then connecting the two lines in the middle. Nothing about the method is a trick; it simply gives your eyes a fresh set of choices.

Look ahead, not only at the pencil

Whichever method you use, glance at the next junction before you move. Most wrong turns are easy to spot one step earlier. Trace lightly so a dead end is easy to retrace, and let a partner point out openings while you draw if that is more comfortable.

For a long maze, work in sections. A plain card laid over the part you are not using keeps your eyes where they should be. The answer page at the back of each PDF shows the full solution line, so you can check a single junction without giving the whole route away.

Solve it with a partner

Mazes are surprisingly social. One person can hold the pencil while the other calls out openings ahead, or one person can work from START while another works from FINISH and the two meet in the middle. Taking turns by junction, rather than by page, keeps both people involved.

If fine pencil work is tiring, trace with a fingertip and let a partner mark the route you point out. On a shared table, print the same maze twice so each person can try a different method, then compare which one reached FINISH first.

Common mistakes and how to avoid them

The most frequent slip is crossing a wall at a corner, where a thin gap can look like an opening. Slow down at corners and look at the whole wall segment. Another is losing track of which branches you have already tried. A light pencil tick at each junction helps: one tick for each branch explored.

A third is pressing too hard, which makes erasing messy, so use a soft pencil and a clean eraser. Finally, remember that there are no loops in these mazes. If your path seems to circle back on itself, you have misread a wall somewhere, and a calm second look at the last few junctions will usually find it.

Pick the level that fits

On the easy mazes, the corridors are wide and the route is short, which suits a first attempt or a quick conversation-friendly activity. The medium level has more junctions and slightly narrower paths. Hard mazes fill the page with passages, so use the large print view and trace lightly.

Try the same easy maze with each of the three methods and notice which one feels natural. For more help picking a level, read the guide to choosing puzzle difficulty.

Put it into practice

More guides